| Scalar Object |
| cportQosRLConfigEntry | .1.3.6.1.4.1.9.9.189.1.1.1.1 |
A collection of rate-limit configuration
objects for a particular interface. Entries
in the cportQosRLConfigTable are created and
deleted by non-SNMP methods. Creation of these
entries is dependent upon configuration of a
physical interface. Further, the physical
interfaces which are configured for port-qos,
can only have these entries.
The ifIndex in the INDEX clause identifies the
interface number for a physical interface. |
| cportQosTSConfigEntry | .1.3.6.1.4.1.9.9.189.1.2.1.1 |
A collection of traffic shaping action
configuration objects for a particular interface.
Entries in the cportQosTSConfigTable are created
and deleted by non-SNMP methods. Creation of these
entries is dependent upon configuration of a
physical interface. Further, the physical interfaces
which are configured for port-qos, can only have
these entries.
The ifIndex in the INDEX clause identifies the
interface number for a physical interface. |
| cportQosIndexType | .1.3.6.1.4.1.9.9.189.1.3.1 |
This object specifies the sorting mechanism used to
collect and store the statistical QoS information.
This object value is device dependent and it could be
optionally configured via command-line. |
| cportQosStatsEntry | .1.3.6.1.4.1.9.9.189.1.3.2.1 |
Each entry in this table describes the QoS port
statistical information which are : pre/post policy
pkts/octets counts, drop pkts/octets,
classified pkts/octets. |
| Tabular Object |
| cportQosRLConfigDirection | .1.3.6.1.4.1.9.9.189.1.1.1.1.1 |
The direction in which the rate-limit is applied
to packet:
input statistics of the input packets.
output statistics of the output packets. |
| cportQosRLConfigEnable | .1.3.6.1.4.1.9.9.189.1.1.1.1.2 |
This indicates the rate-limit is enabled or disabled.
A value of true(1) indicates the rate-limit is enabled
and a value of false(2) indicates it's disabled.
Writing a value of true(1) to this object also
requires writing a valid value to the
cportQosRLConfigRate at the same time.
Writing to cportQosRLConfigBurstSize is optional. |
| cportQosRLConfigRate | .1.3.6.1.4.1.9.9.189.1.1.1.1.3 |
This is the sustained rate permitted by the rate
limit.
Writing to this object also requires writing a value of
true(1) to cportQosRLConfigEnable at the same time. |
| cportQosRLConfigBurstSize | .1.3.6.1.4.1.9.9.189.1.1.1.1.4 |
The burst size. The amount of traffic, in bytes,
in excess of the sustained rate which will be
instantaneously permitted by the rate limit.
Writing to this object also requires writing a value
of true(1) to cportQosRLConfigEnable and a valid value
to the cportQosRLConfigRate at the same time. |
| cportQosTSConfigEnable | .1.3.6.1.4.1.9.9.189.1.2.1.1.1 |
This indicates the traffic shaping is enabled or
disabled. A value of true(1) indicates the traffic
shaping is enabled and a value of false(2) indicates
it's disabled.
Writing a value of true(1) to this object also
requires writing a valid value to the
cportQosTSConfigRate at the same time.
Writing to cportQosTSConfigBurstSize is optional. |
| cportQosTSConfigRate | .1.3.6.1.4.1.9.9.189.1.2.1.1.2 |
This is the sustained rate permitted by the
traffic shaping. Writing to this object also
requires writing a value of true(1) to
cportQosTSConfigEnable at the same time. |
| cportQosTSConfigBurstSize | .1.3.6.1.4.1.9.9.189.1.2.1.1.3 |
The amount of traffic, in bits, in excess
of the sustained traffic shaping rate that
will be instantaneously permitted by this feature.
Writing to this object also requires writing a value
of true(1) to cportQosTSConfigEnable and a valid value
to the cportQosTSConfigRate at the same time. |
| cportQosDirection | .1.3.6.1.4.1.9.9.189.1.3.2.1.1 |
The direction of the reported statistics:
-'ingress' statistics for the input direction.
-'egress' statistics for the output direction. |
| cportQosIndex | .1.3.6.1.4.1.9.9.189.1.3.2.1.2 |
An arbitrary integer to identify this entry.
cportQosIndex value, which may have non-contiguous
range, is linked to cportQosIndexType:
-if cportQosIndexType equals 'none', cportQosIndex
is constant with the value of 1 and all statistics
are classified per port
-if cportQosIndexType equals 'dscp', cportQosIndex
range is from 1 to 65 and all statistics are
classified per port and dscp value. The range
of dscp values reported is shifted up one meaning
a cportQosIndex of 1 translates to a packet dscp
value of 0.
Value of 65 is an arbitrary number used to report
aggregate counts of packets which were not displayed
in the 1 to 64 range. This usually happens when the
range value of cportQosIndex is non-contiguous
-if cportQosIndexType equals 'ipPrecedence',
cportQosIndex range is from 1 to 8 and all
statistics are classified per port and ip precedence
value. The range of ip precedence values reported
is shifted up one meaning a cportQosIndex of 1
translates to an ip precedence value of 0
-if cportQosIndexType equals 'cos',
cportQosIndex range is from 1 to 8 and all
statistics are classified per interface and L2 cos
value. The range of cos values reported
is shifted up one meaning a cportQosIndex of 1
translates to a cos value of 0
|
| cportQosPrePolicyPkts | .1.3.6.1.4.1.9.9.189.1.3.2.1.3 |
The count of packets prior to executing any QoS
policies. |
| cportQosPrePolicyOctets | .1.3.6.1.4.1.9.9.189.1.3.2.1.4 |
The count of octets prior to executing any QoS
policies. |
| cportQosPostPolicyPkts | .1.3.6.1.4.1.9.9.189.1.3.2.1.5 |
The count of packets after executing QoS policies. |
| cportQosPostPolicyOctets | .1.3.6.1.4.1.9.9.189.1.3.2.1.6 |
The count of octets after executing QoS policies. |
| cportQosDropPkts | .1.3.6.1.4.1.9.9.189.1.3.2.1.7 |
The count of dropped packets as the result of all
QoS features that can produce drops. |
| cportQosDropOctets | .1.3.6.1.4.1.9.9.189.1.3.2.1.8 |
The count of dropped octets as the result of all
QoS features that can produce drops. |
| cportQosClassifiedOctets | .1.3.6.1.4.1.9.9.189.1.3.2.1.9 |
The count of classified octets during QoS. |
| cportQosClassifiedPkts | .1.3.6.1.4.1.9.9.189.1.3.2.1.10 |
The count of classified packets during QoS. |
| cportQosNoChangePkts | .1.3.6.1.4.1.9.9.189.1.3.2.1.11 |
The count of packets maintain unchange after
executing QoS policies. |
| cportQosNoChangeOctets | .1.3.6.1.4.1.9.9.189.1.3.2.1.12 |
The count of octets maintain unchange after
executing QoS policies. |
| Table |
| cportQosRLConfigTable | .1.3.6.1.4.1.9.9.189.1.1.1 |
A table of rate limit configuration entries.
Rate Limiting is a method of traffic control. It allows
a set of rate limits to be configured and applied to
packets flowing into/out of an interface to regulate
network traffic. |
| cportQosTSConfigTable | .1.3.6.1.4.1.9.9.189.1.2.1 |
A table of traffic-shaping action configuration
entries. |
| cportQosStatsTable | .1.3.6.1.4.1.9.9.189.1.3.2 |
This table specifies QoS port related Statistical
information. |
| Object Identifier |
| ciscoPortQosMIB | .1.3.6.1.4.1.9.9.189 |
Cisco PORT QOS MIB - Overview
This MIB module is for the management of Cisco's
per port rate-limiting and traffic shaping on L3
switch/Router Platform(s).
Per-port rate-limiting is a traffic control method.
A set of rate limits are applied to the traffic
traversing an interface. Each rate limit has a
configurable action that is taken when rate
limiting criteria is met.
Per-port traffic shaping is a traffic control
method. The user can restrict the amount of traffic
coming out of a physical port. Excess traffic is
buffered within the router/switch to the extent
possible.
This MIB module also provides per port QoS statistics. |
| ciscoPortQosMIBObjects | .1.3.6.1.4.1.9.9.189.1 |
| cportQosRLConfig | .1.3.6.1.4.1.9.9.189.1.1 |
| cportQosTSConfig | .1.3.6.1.4.1.9.9.189.1.2 |
| cportQosStatistics | .1.3.6.1.4.1.9.9.189.1.3 |
| ciscoPortQosMIBNotifications | .1.3.6.1.4.1.9.9.189.2 |
| ciscoPortQosMIBConformance | .1.3.6.1.4.1.9.9.189.3 |
| ciscoPortQosMIBCompliances | .1.3.6.1.4.1.9.9.189.3.1 |
| ciscoPortQosMIBGroups | .1.3.6.1.4.1.9.9.189.3.2 |
| Group |
| ciscoPortQosMIBGroup | .1.3.6.1.4.1.9.9.189.3.2.1 |
A collection of objects providing Port QoS
features. |
| ciscoPortQosStatsMIBGroup | .1.3.6.1.4.1.9.9.189.3.2.2 |
A collection of objects providing per Port QoS
statistics.
Replaced by: ciscoPortQosStatsMIBGroupRev1 |
| ciscoPortQosStatsMIBGroupRev1 | .1.3.6.1.4.1.9.9.189.3.2.3 |
A collection of objects providing per Port QoS
statistics. |